Infineon TLE4998C4HALA1

霍尔效应单路PWM±50mT，±100mT，±200mT4.5V ~ 5.5V

Overview

The linear Hall IC TLE4998C has been designed specifically to meet the requirements of highly accurate angle and position detection as well as for current measurement applications. The sensor provides a digital SPC (Short PWM Code) signal, based on the standardized SENT (Single Edge Nibble Transmission, SAE J2716) protocol. The SPC protocol allows transmissions initiated by the ECU. Two further operation modes are available: “range selection” for dynamical switching of the measurement range during operation ,“ID selection” to build a bus system with up to 4 ICs on a single output line and a common supply, which can be individually accessed by the ECU. Each transmission sequence contains an adjustable number of nibbles representing the magnetic field, the temperature value and a status information of the sensor.The output stage is an open-drain driver pulling the output pin to low only. Therefore, the high level needs to be obtained by an external pull-up resistor. This output type has the advantage that the receiver may use an even lower supply voltage (e.g. 3.3 V). In this case the pull-up resistor must be connected to the given receiver supply. The IC is produced in BiCMOS technology with high voltage capability, and it also has reverse-polarity protection. Digital signal processing using a 16-bit DSP architecture together with digital temperature compensation guarantee excellent long-time stability compared to analog compensation methods. While the overall resolution is 16 bits, some internal stages work with resolutions up to 20 bits.

Features

Cut Tape (CT) Package
Hall Effect Technology
Single Axis
PWM Output Type
±50mT, ±100mT, ±200mT Sensing Range
4.5V ~ 5.5V Voltage - Supply
8mA Current - Supply (Max)
5mA Current - Output (Max)
16 b Resolution
Programmable Bandwidth
Selectable Scale, Temperature Compensated Features
Through Hole Mounting Type