NXP PCA9617ADP-ARD

Arduino接口板

Overview

The PCA9617ADPJ is a CMOS integrated circuit that provides level shifting between low  voltage (0.8 V to 5.5 V) and higher voltage (2.2 V to 5.5 V) Fast-mode Plus (Fm+) I2C-bus  or SMBus applications. While retaining all the operating modes and features of the I 2C-bus system during the level shifts, it also permits extension of the I2C-bus by providing  bidirectional buffering for both the data (SDA) and the clock (SCL) lines, thus enabling two  buses of 540 pF at 1 MHz or up to 4000 pF at lower speeds. Using the PCA9617ADPJ  enables the system designer to isolate two halves of a bus for both voltage and  capacitance. The SDA and SCL pins are overvoltage tolerant and are high-impedance  when the PCA9617ADPJ is unpowered.The 2.2 V to 5.5 V bus port B drivers have the static level offset, while the adjustable  voltage bus port A drivers eliminate the static offset voltage. This results in a LOW on the  port B translating into a nearly 0 V LOW on the port A which accommodates the smallervoltage swings of lower voltage logic.The static offset design of the port B PCA9617ADPJ I/O drivers prevents them from being  connected to the static or incremented offset of other bus buffers. Port A of two or more  PCA9617As can be connected together, however, to allow a star topography with port A  on the common bus, and port A can be connected directly to any other buffer with static or incremented offset outputs. Multiple PCA9617As can be connected in series, port A to  port B, with no build-up in offset voltage with only time of flight delays to consider.The PCA9617ADPJ drivers are not enabled unless VCC(A) is above 0.8 V and VCC(B) is above  2.2 V. The EN pin is referenced to VCC(B) and can also be used to turn the drivers on and  off under system control. Caution should be observed to only change the state of theenable pin when the bus is idle.The output pull-down on the port B internal buffer LOW is set for approximately 0.55 V, while the input threshold of the internal buffer is set about 90 mV lower (0.45 V). When the  port B I/O is driven LOW internally, the LOW is not recognized as a LOW by the input.  This prevents a latching condition from occurring. The output pull-down on port A drives a  hard LOW and the input level is set at 0.35VCC(A) to accommodate the need for a lower  LOW level in systems where the low voltage side supply voltage is as low as 0.8 V.

Features

Box Package
Arduino Platform
Interface Type
Level Shifter Function
PCA9617A Utilized IC / Part
Board(s) Contents