NXP PCA9553DP/01,118

线性2.3V5.5V25mA

Overview

The PCA9553DP/01,118 LED blinker blinks LEDs in I²C-bus and SMBus applications where it is necessary to limit bus traffic or free up the I²C-bus master's (MCU, MPU, DSP, chipset, etc.) timer. The uniqueness of this device is the internal oscillator with two programmable blink rates. To blink LEDs using normal I/O expanders like the PCF8574 or PCA9554, the bus master must send repeated commands to turn the LED on and off. This greatly increases the amount of traffic on the I²C-bus and uses up one of the master's timers. The PCA9553DP/01,118 LED blinker instead requires only the initial set-up command to program BLINK RATE 1 and BLINK RATE 2 (i.e., the frequency and duty cycle). From then on, only one command from the bus master is required to turn each individual open-drain output ON, OFF, or to cycle at BLINK RATE 1 or BLINK RATE 2. Maximum output sinks current is 25 mA per bit and 100 mA per package.

Due to pin limitations, the PCA9553DP/01,118 is not featured with hardware address pins. The PCA9553/01 and the PCA9553/02 have different fixed I²C-bus addresses allowing operation of both on the same bus.

Features

Tape & Reel (TR) Package
Linear Type
Yes Internal Switch(s)
4 Number of Outputs
2.3V Voltage - Supply (Min)
5.5V Voltage - Supply (Max)
25mA Current - Output / Channel
400kHz Frequency
I²C Dimming
Surface Mount Mounting Type