NXP PCA9551BSHP

电源开关2.3V5.5V25mA

Overview

The PCA9551BSHP LED blinker blinks LEDs in I²C-bus and SMBus applications where it is necessary to limit bus traffic or free up the I²C-bus master's (MCU, MPU, DSP, chipset, etc.) timer. The uniqueness of this device is the internal oscillator with two programmable blink rates. To blink LEDs using normal I/O expanders like the PCF8574 or PCA9554, the bus master must send repeated commands to turn the LED on and off. This greatly increases the amount of traffic on the I²C-bus and uses up one of the master's timers. The PCA9551BSHP LED blinker instead requires only the initial set-up command to program BLINK RATE 1 and BLINK RATE 2 (i.e., the frequency and duty cycle) for each individual output. From then on, only one command from the bus master is required to turn each individual open-drain output on, off, or to cycle at BLINK RATE 1 or BLINK RATE 2. Maximum output sinks current is 25 mA per bit and 100 mA per package.

The newer Fast-mode Plus PCA9634 8-bit LED controller offers an individual PWM dimming control for each channel for better color mixing capabilities with a global PWM for dimming or blinking all channels at the same time. There are 126 possible address combinations and the maximum output sink current is 25 mA per bit and 200 mA per package.

Features

Tape & Reel (TR) Package
Available in the 16-VQFN Exposed Pad package
Operating temperature of -40°C~85°C TA

Surface Mount Mounting Type

Applications

There are a lot of NXP USA Inc.
PCA9551BSHP LED Driver ICs applications.

• Stage and Studio lighting
• Refrigeration lighting
• Portable lighting
• Gallery lighting
• Museum lighting
• High-end retail lighting
• Medical surgery lighting
• Replacement lamps
• Panel lighting
• Down lights