NXP PCA9550DP,118

线性2.3V5.5V25mA

Overview

The PCA9550DP,118 LED blinker blinks LEDs in I²C-bus and SMBus applications where it is necessary to limit bus traffic or free up the I²C master's (MCU, MPU, DSP, chipset, etc.) timer. The uniqueness of this device is the internal oscillator with two programmable blink rates. To blink LEDs using normal I/O expanders like the PCF8574 or PCA9554, the bus master must send repeated commands to turn the LED on and off. This greatly increases the amount of traffic on the I²C-bus and uses up one of the master's timers. The PCA9550DP,118 LED blinker instead requires only the initial set-up command to program BLINK RATE 1 and BLINK RATE 2 (i.e., the frequency and duty cycle). From then on, only one command from the bus master is required to turn each individual open-drain output ON, OFF, or to cycle at BLINK RATE 1 or BLINK RATE 2. Maximum output sinks current is 25 mA per bit and 50 mA per package.

One hardware address pin on the PCA9550DP,118 allows two devices to operate on the same bus.

Features

Tape & Reel (TR) Package
Linear Type
Yes Internal Switch(s)
2 Number of Outputs
2.3V Voltage - Supply (Min)
5.5V Voltage - Supply (Max)
25mA Current - Output / Channel
400kHz Frequency
I²C Dimming
Surface Mount Mounting Type