Altera ES1010SI

热插拔控制器1闭锁故障

Overview

Altera Enpirion ES1010SI 12V Hot-Swap Power Distribution Controller is a full featured hot-swap power controller that targets +12V applications. Features include soft start, programmable overcurrent detection, current regulation with time delay to latch-off, all with a minimum of external components. Designers can increase the long-term reliability of their FPGA based systems by enabling the safe insertion and removal of boards by limiting dangerous inrush currents from a live backplane. When boards are inserted into a "live" system backplane, the hot swap controller detects the power supply and provides a carefully controlled power ramp up. Designers of telecommunications, enterprise, storage systems, and industrial and embedded computing equipment can upgrade or replace system boards without having to power down the entire system. Upon initial power-up, the IC can either isolate the voltage supply from the load by holding the external N-Channel MOSFET switch off or apply the supply rail directly to the load for true hot swap capability. The Enable pin must be pulled low for the device to isolate the power supply from the load. With the Enable pin held high or floating, the ES1010SI will be in true hot swap mode.

Features

Enpirion® Series
Features of Latched Fault
Programmable features of Current Limit, Fault Timeout, Slew Rate, UVLO
Enpirion® series

Surface Mount Mounting Type

Applications

There are a lot of Intel
ES1010SI hot swap controllers applications.

• Avionics systems
• Safe board insertion and extraction
• Industrial computers and servers
• Redundant-array-of-independent-disk (RAID) storage
• Other forms of communications infrastructure
• Board or blade insertion into live backplanes
• Backplane
• Loads
• Distributed power systems
• Redundant negative voltage supplies