ST VNH5050A-E

驱动器 - 全集成，控制和功率级30A5.5V ~ 18V

Overview

The VNH5050A-E is a full bridge motor driver intended for a wide range of automotive applications. The device incorporates a dual monolithic high-side driver and two low-side switches. All switches are designed using STMicroelectronics® well known and proven proprietary VIPower® M0 technology that allows to efficiently integrate on the same die a true Power MOSFET with an intelligent signal/protection circuitry. The three dies are assembled in a PowerSSO-36 TP package on electrically isolated lead frames. This package, specifically designed for the harsh automotive environment offers improved thermal performance thanks to exposed die pads. Moreover, its fully symmetrical mechanical design allows superior manufacturability at board level. The input signals INA and INB can directly interface to the microcontroller to select the motor direction and the brake condition. The DIAGA/ENA or DIAGB/ENB, when connected to an external pull-up resistor, enables one leg of the bridge. Each DIAGA/ENA provides a digital diagnostic feedback signal as well. The normal operating condition is explained in the truth table. The CS pin allows monitoring the motor current by delivering a current proportional to its value when CS_DIS pin is driven low or left open. When CS_DIS is driven high, CS pin is in high impedance condition. The PWM, up to 20 KHz, allows to control the speed of the motor in all possible conditions. In all cases, a low level state on the PWM pin turns off both the LSA and LSB switches.

■ Output current: 30 A ■ 3 V CMOS compatible inputs ■ Undervoltage and overvoltage shutdown ■ Overvoltage clamp ■ Thermal shutdown ■ Cross-conduction protection ■ Current and power limitation ■ Very low standby power consumption ■ PWM operation up to 20 KHz ■ Protection against loss of ground and loss of VCC ■ Current sense output proportional to motor current ■ Output protected against short to ground and short to VCC ■ Package: ECOPACK®

Features

ECOPACK®, VIPower™ Series
Applications : Automotive
Load voltage across the chip 5.5V~18V
base on VNH5050 number
designed with 1 outputs

Surface Mount Mounting Type

Applications

There are a lot of STMicroelectronics
VNH5050A-E motor drivers applications.

• Mobile phone display backlight and key light driving
• High power LED street light
• Large outdoor LED display
• Commercial office
• Hospitality buildings
• Smart lighting applications
• Automotive applications
• Dome
• Dash
• Footwell lighting