ST STEF05DPUR

电子保险丝

Overview

The STEF05 is an integrated electronic fuse optimized for monitoring output current and input voltage. Connected in series to a 5 V rail, it is capable of protecting the electronic circuitry on its output from overcurrent and overvoltage. The device has a controlled delay and turn-on time. When an overload condition occurs, the STEF05 limits the output current to a predefined safe value. If the anomalous overload condition persists, it goes into an open state, disconnecting the load from the power supply. If a continuous short-circuit is present on the board, when power is re-applied the E-fuse initially limits the output current to a safe value, and then again goes into an open state. The device is equipped with a thermal protection circuit. The intervention of the thermal protection is signalled to the board monitoring circuits through a signal on the Fault pin. Unlike mechanical fuses, which must be physically replaced after a single event, the E-fuse does not degrade in its performance after short-circuit/thermal protection interventions and it is reset either by recycling the supply voltage or using the Enable pin. The companion chip for 12 V power rails is also available with part number STEF12.

Features

Tape & Reel (TR) Package
Tape & Reel (TR) package
STEF05 family
The maximal supply voltage of 10V

Surface Mount Mounting Type

Applications

There are a lot of STMicroelectronics
STEF05DPUR Current Regulation/Managements applications.

• Power management
• Programmable current source
• Automotive current measurement
• Industrial applications current measurement
• Battery management
• Over current monitor
• Over-current measurement
• Current sensing
• Motor controls
• Transmission controls